Data receiving board from satellite positioning system "UBLOX NEO-M8T TIME & RAW receiver board with SMA (RTK ready)"

■ This is an article posted on June 2018, 10, so the content of the information may be out of date.

Data reception board from satellite positioning system on Unipos website UBLOX NEO-M8T TIME & RAW receiver board with SMA (RTK ready) Page has been added.

UBLOX NEO-M8T TIME & RAW receiver board with SMA (RTK ready) Is an evaluation board equipped with UBLOX module NEO-M8T that receives TIME and RAW data from satellite positioning systems such as GPS / US, GLONASS / Russia, Galileo / Europe, BeiDou / China, QZSS / Japan, and SBAS. . It is equipped with SMA antenna connector on a board of only 40 x 18 mm / 8.1 g, which is ultra small and lightweight, and is suitable for mounting on RTK systems, UAV systems, robots, radio control systems, FPV systems, etc.

【Main Specifications】

・ 72-channel u-blox M8 engine GPS / QZSS L1 C / A, GLONASS L10F, BeiDou B1 SBAS L1 C / A: WAAS, EGNOS, MSAS Galileo-ready E1B / C
・ SuperSense Indoor GPS, -167dBm
・ On-board Ultra low noise 3.3V voltage regulator and RF filter for noise blocking
・ USB, I2C and Uart (Tx, Rx) RAW data out avail
・ Support active antenna
・ U-center GPS Evaluation Software
・ Extensive visualization and evaluation features
・ Supports AssistNow Online and AssistNow Offline A-GPS services
・ 1 TTL UART port, 1 USB port, 1 I2C port
・ Time pulse LED
・ Flash memory for firmware upgrade and settings inside in the module (can save settings without battery)
・ Battery for HOT module start
・ Dimensions: 40x18mm
・ Weight 8.1 gram
・ Fully assembled and ready to use